Converts a Stan's 3.30/3.30Ti rear hub to a 12mm thru-axle. Compatible with both Type 1 and Type 2 rear hubs.
- Weight-optimized, gravity-inspired front hub - 32mm-diameter oversized bearings allow adaptability up to 20mm thru axles - Unique flange design reduces dish requirement and minimizes tension range between drive-side and non-drive-side spokes - Compatible with 32 HEX front hub adapters only - Advanced seal system improves prevention of bearing contamination
Direct power meets simplicity—running smoothly day-in and day-out. The 350 hub was developed according to the credo: Reliability meets simplicity. The simultaneous engagement of the ratchets and the resulting large engagement area provide reliability. The plugged construction allows easy maintenance without the need for tools. Adaptation to different axle standards or modification of the engagement angle is also possible with just a few manual steps.
$75.99 - $89.99
Shimano XT FH-M8010/M8000 Rear Hubs. - Double contact bearing seals - Super polished bearing races for low friction rolling - Shimano Quick-engagement freehub - Not compatible with Shimano 11-Speed Road cassettes - Cone bearings races ground by a Cubic Boron Nitride tool for smooth-rolling durability - Center Lock disc brakes provide reliable braking power (lockring sold separately)
$15.00 - $20.00
Stan's 3.30/3.30Ti Hub Kit converts Stan's 3.30 front hubs from quick-release to through-axle compatible. Installation is easy—just pull the old ones off and put the new ones on. Conversion kits available in 12mm and 15mm.
Page 1 of 1